Cooper Security i-on160EX Instalační příručka Strana 99

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 180
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 98
i-on160 Installer Menu Options
Page 93
Signal Strengths
This option allows you check the received signal strength from all the radio
transmitters belonging to the system.
The keypad display shows first: the strength of the most recent signal it has
received from a transmitter, and second: (in brackets) the minimum strength
signal it has received from the transmitter since the records were last reset.
The control unit is always recording signal strengths, whether or not you are
using the Signal Strength menu.
Note: If you have fitted a WAM to act as a repeater for weak detector signals
then you will not see any change in the signal strength reported for those
detectors. However, you should note the signal strength of the WAM,
since that device is now passing on the information from the detectors
whose signal you are trying to amplify.
To reset the signal strength records press “D” while you are in the Tests – Signal
Strength menu. When you press “D” then the control unit resets the signal
strength records for ALL transmitters.
You can also reset the signal strength record of individual transmitters. To do
this press “#” while the display shows the signal strength of the transmitter
you wish to reset.
There are four sections to the Signal Strength menu: Detector Signals, Radio
Sirens, Radio Keypads, and WAMs. Press u or n followed by > to select the
section you want to test.
Detectors
The display shows the strength of the most recently received signal from each
learned radio zone (zones 17 to 40). The bottom line of the display shows the
zone name. To see the zone number press < or >.
Radio Keypads
The display shows a list of the received signal strengths from each radio
keypad.
External Sirens
The display shows a list of the received signal strengths from each 760ES
siren.
WAM Signals
The display shows a list of the received signal strengths from each learned
WAM.
Outputs
This option has three sections: Radio Outputs, Wired Outputs and Plug-by Outputs.
Press u or n followed by > to select the section you want to test.
Within each section the bottom line of the display shows one from a list of
outputs belonging to the section. Press u or n to display the output you wish
to test then press > to activate the output. Press Y to finish the test.
When you complete testing the outputs check that they are in the state you
wish to leave them in.
Zobrazit stránku 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 179 180

Komentáře k této Příručce

Žádné komentáře