Cooper Security i-on160EX Instalační příručka stáhnout pdf (Strana 127)

i-on160 Step by Step Programming Procedures

Page 121

than one Partition. Press u or n to see the other

partitions. See page 52 for more information

about partitions.

If you want to allocate a keypad to all partitions

at once:

Press u or n until the bottom line shows “All

Partitions”.

Press > or < until the end of the bottom line

shows:

Either “Yes” to allocate the keypad to all

partitions

Or “No” to remove the keypad from all partitions

except partition 1.

Radio Kpd 02

All partitions Yes

12. Press Y to confirm your changes.

Radio Kpd 02

Partitions >

13. Carry on with any other pro

rammin

that you

need to do. DON’T FORGET to leave the Installer

Menu in order to save the changes you have

made (see page 7 ).

Naming and Programming Quick Set Keys

Note: This procedure applies equally to wired keypads or radio keypads. The

examples shown are for wired keypads.

1. Enter Installer Menu.

INSTALLER MENU

Detectors/Devices >

2. Press Y.

DETECTOR/DEVICES

Detectors >

3. EITHER:

Press n until the display shows:

DETECTOR DEVICES

Wired Keypads >

4. Press Y.

The display shows:

WIRED KEYPADS

Address Bus Device>

5. Press n until the display shows:

WIRED KEYPADS

Edit Keypad >

6. Press Y.

The bottom line of the display shows the first in

a list of avaiable wired keypads:

EDIT WIRED KEYPADS

Keypad K1-51 >

7. Press u or n to select the keypad that you wish

to program. Then press Y.

Keypad K1-51

Name >

8. Press n until the bottom line of the display

shows the key you wish to edit, for example:

Keypad K1-51

Key A >

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 179 180

Komentáře k této Příručce

Žádné komentáře

Cooper Security i-on160EX Instalační příručka Strana 127

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper Security i-on160EX