Cooper Security i-on160EX Instalační příručka stáhnout pdf (Strana 9)

i-on160 Introduction

Page 3

External Bell Output

The control unit has one external bell output to drive standard Self-Activating

Bell (SAB) or Self-Contained Bell (SCB) modules. Expanders also provide

connectors for additional external sounders. See i-on160EX Installation Guide

for details of maximum current available for external bells.

Extension Loudspeaker Connectors

If required the Installer can connect one 16Ohm extension loudspeaker to

increase the audibility of setting and unsetting tones. Each expander also

provides connectors for a 16Ohm extension loudspeakers. Note that you must

not connect another loudspeaker in parallel to these connectors.

Battery Backup

As noted above, the case provides space for two 17Ah backup batteries. Each

battery has its own connector on the control unit pcb, and is charged by the

control unit while mains power is present.

It is possible to run the system with a single backup battery (although the

resulting standby time may not meet the Grade 2 or Grade 3 requirements). If

you chose to use a single battery, then you should connect the battery to

connector “BATT1” and program the control unit to suppress alerts that Battery

2 is missing, see page 72.

Keypads

The i-on160EX uses i-kp01 keypads with keypad firmware version 2.0 and

above. The keypad has a two line by 20 character backlit LCD display and a

built in proximity tag (prox tag) reader. All keypads connect directly to the

system bus.

Users can set and unset the system or partitions from the keypad, either by

keying-in access codes or presenting a prox tag.

Provided that they are in separate partitions, the control unit can process up to

five keypads in use at the same time. Within a partition, the control unit

responds to just one keypad at a time. In a part setting system (one not using

partitions) the control unit responds to just one keypad at a time.

The Installer can also program the system from the keypad.

Expanders

Wired Expander The EXP-W10 wired expander provides connections for:

Either 10 FSL zones or five CCL zones.

One loudspeaker

Four wired programmable outputs

Radio Expander The radio expanders provide channels for either 10 radio

detectors (EXP-R10) or 30 radio detectors (EXP-R30). In

addition each radio expander provides channels for: two

radio keypads, two external radio sounders and two Wireless

Accessory Modules (WAMs). Each radio expander also

provides wired connections for a Loudspeaker.

Note: The total number of radio detectors that can be

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 179 180

Komentáře k této Příručce

Žádné komentáře

Cooper Security i-on160EX Instalační příručka Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper Security i-on160EX