
Step by Step Programming Procedures i-on160
Page 126
1. Enter Installer Menu.
INSTALLER MENU
Detectors/Devices >
2. Press Y.
DETECTORS/DEVICES
Detectors
3. Press n until the bottom line of the display
shows:
DETECTORS/DEVICES
External Sirens >
4. Press Y .
EXTERNAL SIRENS
Add/Del Ext Siren >
5. Press Y.
The bottom line of the display shows the first of
the available radio expanders.
Note: This example assumes that your radio
expanders are bus devices 02 and 05. The
numbers may be different on the system you
are working on.
ADD/DEL EXT SIREN
Exp. R1-02 (R30)>
6. If required press u or n to select the expander
that you wish allocate the radio keypad to.
ADD/DEL EXT SIREN
Exp. R1-05 (R10)>
7. Press Y .
The bottom line of the display shows the first in
a list of device addresses used by radio sirens on
that expander. If a radio siren has already been
learned by the system then the bottom line of
the display shows a “*” at the beginning of the
line, and the siren name.
ADD/DEL EXT SIREN
Siren R1-05-01 >
8. Press u or n keys to show the siren you want to
delete.
ADD/DEL EXT SIREN
*Siren 01 >
9. Press Y.
The display asks if you wish to delete this radio
siren. (Press X if you wish to leave the siren in
place.)
ADD/DEL EXT SIREN
Delete Ext Siren?
10. Press Y.
The display asks you to confirm that you wish to
delete this radio siren. (Press X if you wish to
leave the siren in place.)
ADD/DEL EXT SIREN
Are you sure?
11. Press Y.
The keypad also sounds a double “beep” when
the control unit successfully deletes the siren.
The display no longer shows “*” at the beginning
of the bottom line, indicating that there is no
siren learned at the displayed device address.
ADD/DEL EXT SIREN
Siren R1-05-02 >
Komentáře k této Příručce