Cooper Security i-on160EX Instalační příručka stáhnout pdf (Strana 42)

Installer Menu Options i-on160

Page 36

Use this zone type to monitor the fault output of an external PSU. (This

zone type is available for power supplies that do not provide specific fault

outputs that can be used by zone types 11, 12 and 13.) If a power supply

triggers a zone with this type then the control unit activates any output

programmed as “External PSU Fault” and causes an alert that displays

“External power fault” on the keypad.

If the alarm system is set then the control unit logs the event, starts any

programmed communication, but does not start an alarm.

Note: Zone type 15 is not used.

Log Only (16)

When a detector triggers a zone with this type the control unit logs the

event and activates any outputs that are programmed to follow this zone.

The zone is active whether the system is set or unset. Typical uses for this

zone type are for integrating the alarm system with a CCTV system.

Note: Zone Follow outputs will activate on both Alarm and Tamper of a Log

Only zone.

Partitions

Note: This menu does not appear if a zone has the type “Not Used”.

In a partitioned system you can assign zones to any of the partitions. Any zone

can belong to one or more partitions.

Note: If you assign a zone to more than one partition then that zone will only

be set when all the partitions it belongs to are set.

When delivered from the factory, or if you restore the control unit to factory

settings, then all zones belong to partition 1.

Once you have entered the Partitions option, press u or n to scroll through

the list of partitions followed by > or < to allocate/deallocate the zone to each

partition as necessary.

If you wish to allocate/deallocate the zones to many partitions you can use the

“All Partitions” option (in between partition 1 and 20 on the menu) to either

allocate or deallocate the zone to all partitions in one operation. Once you have

carried out this operation you can then scroll through the partition list and

change the allocation of zones as necessary.

Zone Attributes

Note: This menu does not appear if a zone has the type “Not Used”.

You can assign more than one attribute to a zone. Some attributes are not

available for certain zone types. The display shows only the available attributes

for the zone type you select.

To enable an attribute for a zone press > or < until the bottom line of the

display shows “Yes” at the right hand end.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 179 180

Žádné komentáře

Cooper Security i-on160EX Instalační příručka Strana 42