Cooper Security i-on160EX Instalační příručka stáhnout pdf (Strana 80)

Installer Menu Options i-on160

Page 74

Phone Book

This option appears only when there is an i-sd02 or i-gsm02 module fitted. Use

this menu to store two telephone numbers that the control unit uses to report

alarms to the ARC. The control unit accepts one telephone number if you

choose Single in the Call Mode menu, or two telephone numbers if you select

Alternate in the Call Mode menu.

The control unit can store telephone numbers up to 31 digits long.

Use the u and n keys to move the cursor backwards and forwards through

the number if you wish to edit it.

Press

< to delete the digit to left of the cursor.

Press * to add a 2 second pause, if required. The display shows this as a

comma.

IP Network

This option appears if a GPRS or Ethernet module is fitted. Use it to program

alarm receiving company destinations that the control unit must report to over

the internet.

Note: Before programming the control unit to use the IP Network please make

sure that:

1. You understand basic IP terminology.

2. You have obtained the necessary information from your Internet

Service Provider.

Unit Name

Use this option to store a unique name for the unit.

Polling IP Address

Key in the IP address of the remote polling engine. If the ARC is not using

a polling engine then leave this option blank.

ARC IP Address

Use this option for the ARC’s main IP addresses. This option provides two

entries for storing a primary and a secondary ARC IP address.

Account Numbers.

To store an ARC account number select Communications – ARC Reporting –

Account Numbers.

If you are programming a partitioned system then the control unit gives you

the opportunity to store an account number for each partition. If you are

programming a Part Setting system then you can store one account number.

With CID reporting the system reports alarms using a four digit account code.

With Fast Format reporting you can use four-, five- or six-digit codes. The

control unit pads five-digit codes to six digits using a leading zero. The control

unit leaves four- and six-digit codes unchanged.

Note: If you need to add a letter to the account code press the numbers keys

repeatedly until the letter you want appears on the display. See page 12.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 179 180

Komentáře k této Příručce

Žádné komentáře

Cooper Security i-on160EX Instalační příručka Strana 80

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper Security i-on160EX