Cooper Security i-on160EX Instalační příručka stáhnout pdf (Strana 107)

i-on160 Step by Step Programming Procedures

Page 101

for at least three seconds.

After three seconds the expander gives a

confirmation tone (two beeps) and its display

shows the address allocated by the control

unit, for example:

Note: DO NOT attempt to address two devices at

the same time.

1- followed by 03

If you do not wish to accept this bus device

number, hold down the Request/Delete

Address button for at least three seconds

again. The control unit will allocate the next

free number, for example:

1- followed by 06

NOTE: If there are no more free bus addresses

then the keypad display will display an error

message. This may happen especially if you

are trying to add an EXP-R30, and there are

not three consecutive bus addresses available.

For Keypads:

Go to the keypad. Hold down keys A and Y for

at least three seconds.

After three seconds the keypad gives a

confirmation tone and its display shows the

address allocated by the control unit, for

example:

Note: DO NOT attempt to address two keypads at

the same time.

b1 d52

V2.0 26/07/10

If you do not wish to accept this bus device

number, hold down A and Y again and the

control unit will allocate the next free number,

for example:

b1 53

V02.0 26/07/10

At this point you can go to any other expander

or keypad device that you wish to add to the

bus and repeat step 9.

10. At the keypad you are usin

g

to pro

g

ram the

system press X when you have finished adding

bus devices.

(If you are adding a keypad the display will

show:)

WIRED EXPANDER

Add Expander

WIRED KEYPAD

Add keypad

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 179 180

Komentáře k této Příručce

Žádné komentáře