Cooper Security 9751 Instalační manuál stáhnout pdf (Strana 49)

3. Installation

496964 Page 41

Fitting a Plug-on Communicator (9851 only)

The 9851 control unit can be fitted with a plug-on communicator. To fit it,

follow the instructions below.

Caution: Before fitting a plug-on communicator, you must power down

the control unit completely, both mains and battery supplies.

When reapplying power, connect the battery first. Failure to do

so may damage the control unit.

Remember to short the Kick Start pins when powering from a battery only.

Plug-on Communicator Signals:

The plug-on communicator uses a variant of the standard Scantronic footprint:

° The functions of the plug-on pins are fixed and cannot be modified.

° All outputs are positive-applied (5V) in alarm.

° All inputs are positive-applied (12V or 5V) to indicate line failure,

communications failure and tell back.

Pin Channel Sent to

ARC

Input /

Output

Signal

1 CH 1 Output Fire

2 CH 2 Output PA

3 CH 3 Output Burg

4 CH 4 Output Close = +ve, Open = -ve

5 CH 5 Output Omit

6 Input Tel Back

7 Input Comms Fail

8 Output Low Batt

9 Power supply 12V

10 Power supply 0V

11 – Not Used

12 Power supply 5V

13 CH 6 (see Note) Output Abort

14 CH 7 (see Note) Output Confirm

15 Input Line Fail

16 CH 8 Output Technical

Note: Some RedCare STUs reverse Channels 6 and 7 so that Confirm is on

pin 13 and Abort is on pin 14. For information on the operation of

RedCare communicators, see the manufacturer's instructions.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 147 148

Žádné komentáře

Cooper Security 9751 Instalační manuál Strana 49