Cooper Security i-on 16 Uživatelská příručka stáhnout pdf (Strana 54)

Programming i-on16

Page 50

Reset System reset 305

Exit timeout Exit timeout and restore 457

Omit Zone omit 573

RF supervision Zone supervision fail and restore

Radio keypad supervision fail and restore

External siren supervision, fail and restore

381

RF jamming Jamming fail and restore 344

Smoke power supply unit fail and restore 337

Zone low battery fail and restore 384

RF battery psu

Ext Siren low battery fail and restore 338

End station low battery and restore 302 Panel battery

End station battery missing and restore 311

Mains Fail Mains fail and restore 301

Smoke fault and restore 373 Faults

Comms line fault and restore 351

Installer mode start 627 Installer mode

Installer mode end 628

Time date reset Time and date reset 625

Restorals

When you enable a CID Report Group, the control unit

sends the relevant telegram both when an event occurs,

and when the condition causing the event stops. The

second transmission of the telegram is also called a

“restore”.

You can enable or disable restoral reporting by selecting

Reporting – Alarms – Restorals. The options available are:

Disabled

Restore off. The control unit does not communicate

restores.

Enabled.

Restore on. The control unit does communicate

restores.

Burg Comms Rearm

This menu option determines what the control unit does

with the “Burg” Fast Format channel 3 at the end of the

siren run time. There are two options:

Disabled

The channel stays active until an Installer or user

resets the system.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

Komentáře k této Příručce

Žádné komentáře

Cooper Security i-on 16 Uživatelská příručka Strana 54

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper Security i-on 16