Cooper Security i-on 16 Uživatelská příručka stáhnout pdf (Strana 44)

Programming i-on16

Page 40

them). The exit time can take any value between 10s and

120s.

Entry Time

This option controls the Entry Time for both Full and Part

Set. The time can take any value between 10s and 120s.

Part Set Exit Mode

You can select an exit mode for part set that is different

from that used during full setting. Page 39 lists the exit

modes available.

Note: If you wish to use Final Door Set exit mode when

part setting then:

1. Make sure that you include a zone with the Final

Exit type as one of the part set zones.

2. Make sure you select “Final Door” in Part Set Final

Exit As (see below).

3. Remember that for Part Set to work you must

have at least one zone with the attribute Part Set =

“Yes”, see page 34 .

Pt. Set Final Exit

This option controls how the system will treat Final Exit

zones in Part set. When the option is set to Final Door

any Final Exit zones with the part set attribute will

continue to act as Final Exit zones during part set. When

the option is set to Normal Alarm any Final Exit zones

included in the part set attribute will act as Normal Alarm

zones during part set.

Pt .Set Entry Route As

This option controls how the system treats Entry Route

zones during part set. When the option is set to Entry

Route all Entry Route zones with the part set attribute will

continue to act as Entry Routes during part set. When the

option is set to Final Exit any Entry Route zones with the

part set attribute will act as Final Exit zones during part

set.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 67 68

Žádné komentáře

Cooper Security i-on 16 Uživatelská příručka Strana 44