Cooper Security i-on 16 Uživatelská příručka stáhnout pdf (Strana 43)

i-on16 Programming

Page 39

Part Set B Name

Use this option to give the Part set mode a name. The

control unit displays this name to the user during setting.

Exit Mode

This option controls the exit mode for Full set. (For Part

Set exit modes see page 40 .) The exit modes available

to both Full Set and Part Set are:

Timed Set.

Use this option to make the system set after a delay.

Use the Exit time menu (see page 39) to choose the

delay.

Final Door Set.

Use this option to complete setting the system by

closing a door fitted with a Final Exit zone detector.

Note that the exit time is infinite in this option.

Note: Do not try to make a PIR zone act as a Final Exit.

Radio PIR detectors have a “lock out” period after

each activation in order to conserve battery power.

When you set (or part set) the system a PIR may still

be in lockout, during which it cannot send a signal to

complete the setting process.

Instant Set.

The system sets immediately and without any tones.

Silent Set.

The system sets after the exit time programmed in

the Entry/Exit Time menu but does not give any exit

tones. When the system sets the keypad gives a

double beep.

The keypad gives a double beep confirmation tone at the

end of all setting modes.

If you select Final Door Set exit mode then the system

allows a seven second settling time after closing a final

door.

Exit Time

This option controls the Exit Time for both Full and Part

set (unless you choose Instant Set for one or both of

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 67 68

Žádné komentáře

Cooper Security i-on 16 Uživatelská příručka Strana 43