Cooper Security i-on 16 Uživatelská příručka stáhnout pdf (Strana 27)

i-on16 Installation

Page 23

6. Fit and Connect Battery

Fit a 7Ah Lead Acid battery into the battery compartment

in the bottom of the control unit, see Figure 21.

Figure 21. Fitting the Battery

Make sure that you secure the battery to the case with

the strap provided. Connect the battery leads, red to the

positive, black to the negative terminals of the battery.

Note: Connecting the battery without mains power will

not start the system. (See “Programming A Control

Unit Before Installation” below if you wish to start the

system on battery power.)

Programming a Control Unit Before Installation

If you prefer, you can make the control unit learn the

detectors and other peripherals before installing the

system in its final location. You will need to temporarily

connect a keypad to the end station.

It is possible to operate the end station from battery

power (or a 12Vdc supply) without connecting the unit to

a mains supply. However, in order to start the end station

processor running you must briefly short the Kick Start

pins together after connecting the battery.

7. Initial Power-Up

WARNING: During initial power-up all the keypad

sounders and any internal loudspeaker will give an alarm

tone. If you are working at the top of a ladder make sure

that the sudden noise does not startle you and cause a

fall.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 67 68

Žádné komentáře

Cooper Security i-on 16 Uživatelská příručka Strana 27