Cooper Security i-on 16 Uživatelská příručka stáhnout pdf (Strana 35)

i-on16 Programming

Page 31

You have the choice of deleting the detector ID or of

defaulting the zone. Press u or n to see each of these

choices.

If you select “Delete Detector ID” then the control unit

“forgets” the ID of the detector, but leaves any zone

programming in place.

If you select “Default zone” then the control unit “forgets”

the ID of the Detector and sets all the zone programming

back to default values: Type = Not Used, no attributes.

To reinstate the detector you must teach the control unit

that detector's identity again.

Edit Zones

Once you have made the control unit learn radio

detectors then you can program each zone's behaviour.

Names, Type, Attributes

To change the name associated with a zone, its type, or

its attributes then select Detectors – Edit Zones .

The bottom line of the display starts at zone 1. Press u

or n to show the other zones. When you have found the

zone you wish to edit press >. The bottom line of the

display shows “Name”. Press u or n to see Type or

Attributes options for that zone. Press

> to select the

option you wish to change.

Changing Zone Names

When changing the zone name, key in the letters from

the keypad. Each number is associated with a range of

letters in the same way as on many mobile phones.

Figure 23 shows which letters appear on each key.

To delete characters press <. If you wish to move the

insertion point, then press u or n.

To change between capital and lower case letters press

#. The cursor changes to an underline when in lower case

mode.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

Žádné komentáře

Cooper Security i-on 16 Uživatelská příručka Strana 35