Cooper Security M2000 Uživatelská příručka stáhnout pdf (Strana 95)

Engineering Manual Engineer Menu 1-9

Latched code o/p – If the output is latched, the output activates when a user code is

entered, then deactivates when the user code is entered again. If the output is pulsed, the

output activates for the duration of the programmed pulse time, then deactivates.

17 – Latching 24hr / Nonlatching 24hr

Latching 24hr – 24 Hour zones (page 22) will cause an alarm when triggered and will be

re-armed only after entering a user code twice (once to silence the alarm, and once to

reset the alarm).

Nonlatching 24hr – 24 Hour zones will cause an alarm when triggered. On entering a user

code, the alarm is silenced. The zone is re-armed immediately after a user code is entered

to silence the alarm.

18 – Access code only / Access all codes

Access code only – Causes outputs that follow the Access Code or Access event (page 45

or 56) to activate only when a user code of type Access is entered.

Access all codes – Causes the outputs to activate when any user code is entered.

19 – NVM is Unlocked / NVM is Locked

NVM is Unlocked – The panel can be reset to its factory defaults by shorting the FACTORY

RESTART pins on the control panel PCB during power-up.

NVM is Locked – The panel cannot be reset to its factory default settings by shorting the

FACTORY RESTART pins. Keypads give a warning sound if the terminals are shorted.

)

If you select this option, it is imperative that you remember the engineer code .

20 – Unshunt, no exit / Unshunt & exit

Unshunt, no exit – Entering a Shunt user code (User option 8-1; see the

Manager's

Manual

) to reinstate zones does not start the exit procedure.

Unshunt & exit – Entering a Shunt user code to reinstate zones starts the exit procedure

for all the appropriate wards within the shunt group that are already set.

21 – Ignore errors / View exit errors

Ignore errors – When setting the system with one or more zones active (i.e. triggered), the

panel continues with the exit procedure, but displays the zones that are currently active. If

the zones are not cleared at the end of the exit procedure, the internal sounder sounds,

the external strobe flashes and the display shows an error.

View exit errors – When setting the system with one or more zones active, the panel

displays the zones that are currently active and does not allow the system to be set while

zones are active. After clearing the active zones, the panel prompts for confirmation to

continue with the exit procedure.

22 – Mimic, All times / Mimic, Set only

Mimic, All times – When using an output of type Mimic (page 58), the output mimics the

zone at all times.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 179 180

Žádné komentáře

Cooper Security M2000 Uživatelská příručka Strana 95