Programming Reference - Reporting 7510r
Page 64
Alternate.
Reports to one of the two telephone numbers in the
Phone Book.
Operation: The control unit dials the first telephone
number and attempts to connect to the receiving
centre. If call fails, the control unit ends the call, dials
the second telephone number and attempts to
connect to the receiving centre. If received and
acknowledged on this attempt, the control will close
down and the alarm transmission will be complete. If
the control unit fails to connect to the second
telephone number, it will close down again and re-
attempt to connect to the first telephone number. The
system will continue to shuttle between the two
numbers up to 15 times.
Phone Book
Select
Reporting
,
Social Care
,
Phone Book
to store the
telephone numbers that the communicator will use to
report social care alarms. The control unit will accept one
telephone number if you choose Single in the Call Mode
menu, or two telephone numbers if you select Alternate
call mode.
The system can store telephone numbers up to 31 digits
long.
Use the u and n keys to move the cursor backwards and
forwards through the number if you wish to edit it.
Use the Delete softkey to delete the digit to right of the
cursor.
Press * to add a two second pause, if required. The
display shows this as a comma.
Account Numbers
Select
Reporting
,
Social Care
,
Account Numbers
to store any
account numbers that you wish the control unit to
communicate during a social care alarm call.
For social care reporting an account code can be up to
eight characters long (digits and letters).
When using Scancom or Scanfast report types (see
below) the control unit uses the last four to six characters
Komentáře k této Příručce