Cooper Security Homelink 75 Uživatelská příručka stáhnout pdf (Strana 41)

7510r Programming Reference - Partitions

Page 37

Siren + Comms

Full alarm (communication and siren).

Part Set Exit Mode

You can select an exit mode for a part set partition that is

different from that used when the same partition is full

set. Page 35 lists the exit modes available.

Note: If you wish to use Final Door Set exit mode when

part setting a partition then:

1. Make sure that you include a zone with Final Exit

type in that partition.

2. Make sure you select “Final Door” in Part Set Final

Exit As (see below).

Part Set Final Exit As

This option controls how the system will treat Final Exit

zones in part set. When the option is set to Final Door

any Final Exit zones included in the partition will continue

to act as Final Exit zones during part set. When the

option is set to Normal Alarm any Final Exit zones

included in the partition will act as Normal Alarm zones

during part set.

Part Set Entry Route As

This option controls how the system treats Entry Route

zones during part set. When the option is set to Entry

Route all Entry Route zones included in the partition will

continue to act as Entry Routes during part set. When the

option is set to Final Exit any Entry Route zones included

in the partition will act as Final Exit zones during part set.

Strobe on Set (770r only)

When set to ON this option causes the control unit to

activate any associated 770r WAM programmed as a

sounder receiver (mode 4). The WAM operates its strobe

output when the partition sets.

Strobe on Unset (770r only)

When set to ON this option causes the control unit to

activate any associated 770r WAM programmed as a

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 83 84

Žádné komentáře

Cooper Security Homelink 75 Uživatelská příručka Strana 41