Cooper Security Homelink 75 Uživatelská příručka stáhnout pdf (Strana 42)

Programming Reference - System Options 7510r

Page 38

sounder receiver (mode 4). The WAM operates its strobe

output while the partition unsets.

System Options

This section of the Installer Menu contains a series of

options that affect the working of the alarm system as a

whole.

User Access

To give users access to various system facilities select

System Options, User Access

. Press the u or n keys to scroll

up or down the list on the display. To allow access press

CHANGE repeatedly until “Y” appears next to the selected

option. To deny access press CHANGE until “N” appears

next to the selected option. Press DONE when you have

finished.

Record Memo

This option allows or prevents users recording a voice

memo message. Any user can replay the memo.

Reset After Alarm

If you wish to allow users to reset the system after an

alarm then select “Y”. If you wish to make sure that only

the Installer can reset the system after an alarm then

select “N”.

Note: If you are programming the system to comply with

BS8473:2006 (see page 79) then select “N” and

control user reset from System Options - Alarm

Confirmation - Reset Unconf/Conf

. See page 46.

Dual Key Function

Enable this option to allow users to start an alarm from

the keypad by pressing two keys at the same time. See

the User Guide for details.

Zone Tamper Reset

Use this option to permit a user to reset the system after

a zone tamper alarm the occurs while the system is

unset.

Choose "Y" to allow user reset after a zone tamper.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

Žádné komentáře

Cooper Security Homelink 75 Uživatelská příručka Strana 42