Cooper Security M2000 Uživatelská příručka stáhnout pdf (Strana 55)

Zone Numbering

Each zone has a unique 4-digit number. Reading from left to right the

meaning of the number is as follows:

For all zones except those using iD Plus biscuits (on an M800iD Plus):

• The first digit is the network number. This is the network number of

the device that the zone is connected to (0 for zones connected to

the control unit PCB). The number of available networks depends on

the type of control unit.

• The next two digits specify the device address that the zone is

connected to (00 for zones connected to the control unit PCB). For

devices such as keypads, the device address is determined by a

link on the device PCB.

The first eight zones on an ID Node have device address 01,

the next eight have device address 02, etc.

• The final digit specifies the zone number on the selected device.

Example: 2031 is: network 2 device address 03 zone 1

For zones using iD Plus biscuits (on an M800iD Plus):

• The first digit is always "2" (represents an imaginary network number

of 2).

• The next three digits specify the zone number.

Only valid zone numbers are displayed as you scroll. For example, if you

are programming an M2000, the next number displayed after 0008

(panel zone 8) is 1011 (network 1, device 01, zone 1).

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 75 76

Žádné komentáře

Cooper Security M2000 Uživatelská příručka Strana 55