Cooper Security M2000 Specifikace stáhnout pdf (Strana 13)

M2000 Installation Instructions 13

Menu. If you lock the NVM DO NOT forget the

engineer passcode.

Serial Printer Connector

("19" in Figure 2.)

Serial printer

(e.g. DATAC )

RS232 Data

Connect to

control pa nel

Figure 17: Using a Printer

The SERIAL PRINTER connector enables a serial

(RS232) printer to be connected directly to the control

panel, such as a DATAC printer. Connection details are

shown in Figure 18.

The printer can, for example, be used to:

• Produce a hardcopy record of system

programming details.

• Print logged events. The system can be configured

to enable online printing, where logged events are

automatically printed as they occur.

The printer must be set up with the following

communication settings: 4800 baud, eight data bits,

one stop bit, one start bit, no parity and DTR normal.

DTR

Pr i n t e r

Serial printer

connector on

control panel

Figure 18: Printer Connections

Output Module Connector

("20" in Figure 2.)

CPA6 output modules (now obsolete) can be

connected to the OUTPUT MODULE connector to

provide eight additional 100mA switched-negative

programmable outputs per module. The outputs can

be used to drive LEDs or other low-power devices (see

Figure 19).

Each output module is supplied with an interface lead,

which enables easy connection to the control panel (or

to an MSNode).

When the output module is connected to the control

panel, the outputs can be programmed to indicate

ward status or zone alarms.

For further details, please refer to the CPA6 Output

Module Installation Instructions.

PL1

1k Resistors

LEDs

1234 567

+12V IN

+12V OUT

+12V OU T

PL2

Connec t to plug

la b e lled OUTPUT

MODULE

100m max.

Figure 19: Output Module Connections

Engineer Keypad Connector

("21" in Figure 2.)

A keypad set with its ID selector switch set "ENG" can

be connected directly to the ENGINEERS KEYPAD

connector on the control panel, using the Engineer

Keypad Interface (EKI) lead. (Figure 20 provides

connection details.)

An engineer's keypad is intended to be temporary

connected to the control panel for system

configuration and testing at the control panel. The

keypad can be disconnected without causing an alarm.

Once a system has been set up, system configuration

should normally be carried out from a keypad

attached to Network 1 or 2.

The zone and output terminals on an engineer's

keypad cannot be used.

Ke y p a d

Fit

polarising

Engineer's keypad

connector on

control panel

Figure 20: Engineer Keypad Connections

Serial Connection to PC

("22" and "23" in Figure 2.)

Optionally, a local PC running the Menvier Downloader

software can be connected to the control panel for

system configuration and data uploading. The PC can

connect to the panel's USB port ("22" in Figure 2) or

Serial RS232 port ("23" in Figure 2).

When using the RS232 port, use a null-modem serial

cable – wiring details are shown in Figure 21.

1 2 ... 8 9 10 11 12 13 14 15 16

Komentáře k této Příručce

Žádné komentáře

Cooper Security M2000 Specifikace Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper Security M2000