Cooper Security i-on40 Instalační příručka stáhnout pdf (Strana 96)

Testing i-on40

Page 92

2. Press >.

The bottom line of the display shows “IP Link Status”.

3. Press >.

The bottom line of the display shows “OK” if the

control unit has successfully connected to a PC by

way of an Ethernet cable.

4. Press < then n.

The bottom line of the display shows “IP Address”.

5. Press >.

The bottom line of the display shows the IP address

currently assigned to the built-in Ethernet port. Note

that this may have been assigned by DHCP.

6. Press < then n.

The bottom line of the display shows “Subnet Mask”.

7. Press >.

The bottom line of the display shows the current

subnet mask. Note that this may have been assigned

by DHCP.

8. Press < then n.

The bottom line of the display shows “Gateway

Address”.

9. Press >.

The bottom line of the display shows the current

gateway address. Note that this may be blank if you

are connecting a PC/laptop directly to the control

unit.

10. Press < then n.

The bottom line of the display shows “MAC address”.

11. Press >.

The bottom line of the display shows the MAC address

used by the built in Ethernet port.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 115 116

Žádné komentáře

Cooper Security i-on40 Instalační příručka Strana 96