Cooper Security i-on40 Instalační příručka stáhnout pdf (Strana 36)

Installer Mode Programming i-on40

Page 32

The i-on40 also lets you change the polarity of the wired

output, to suit the type of equipment that the output

must work with.

To give a wired output a name:

1. Select Outputs – Wired Outputs.

The bottom line of the display shows the first in the

list of four available wired outputs.

2. Press u or n to select the wired output that you wish

to name and press >.

The bottom line of the display shows the word

“Name”.

3. Press > to give the output a name.

See page 7 for hints on editing names.

Press Y when you have finished editing the name.

To give a wired output a type:

1. Select Outputs – Wired Outputs.

The bottom line of the display shows the first in the

list of four available wired outputs.

2. Press u or n to select the wired output that you wish

to give a type and press >.

The bottom line of the display shows the word

“Name”.

3. Press n and then > to see the list of types.

You can select any of the types listed on page 34

onwards.

Press Y to store any changes to the type.

Note: Partitioned Systems

If you are programming a partitioned system then at

this point, for some output types, the top line of the

display shows “Partition?”. The bottom line of the

display shows “Partition 1 Yes”. This means that the

system is asking if you want to allocate the output to

Partition 1.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 115 116

Žádné komentáře

Cooper Security i-on40 Instalační příručka Strana 36