Cooper Security i-on40 Instalační příručka stáhnout pdf (Strana 92)

Testing i-on40

Page 88

WAM Signals

The display shows a list of the received signal strengths

from each learned WAM.

Outputs

This option has three sections: Radio Outputs, Wired

Outputs and Plug-by Outputs. Press u or n followed by >

to select the section you want to test.

Within each section the bottom line of the display shows

one from a list of outputs belonging to the section. Press

u or n to display the output you wish to test then press

> to activate the output. Press Y to finish the test.

When you complete testing the outputs check that they

are in the state you wish to leave them in.

Remotes

To test a remote control:

1. Select Test – Remotes from the Installer Menu.

The display instructs you to press any button on the

remote.

2. Press one button on the remote.

The display identifies the remote and the button you

pressed, shows the user that owns the remote, and

reports the current signal strength.

3. Press all of the buttons on the remote in turn. Make

sure the display reports each button correctly.

4. Press X to end the test.

Panic Alarms

To test a panic alarm:

1. Select Test – Panic Alarm from the Installer Menu.

The display instructs you to press any button on the

panic alarm.

2. Press one button on the panic alarm.

The display shows the user that owns the panic

alarm, and reports current signal strength.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 115 116

Žádné komentáře

Cooper Security i-on40 Instalační příručka Strana 92