Cooper Security i-on160EX Uživatelská příručka stáhnout pdf (Strana 20)

2 Alarms i-on160

Page 14

Press < or > to see the name of

the zone (if the installer has

programmed one), for example:

Press tick to Reset

Hallway

Press Y to restore the display to

normal.

i-on160EX

12:20 02/11/2010

If you wish to see any other zones that were triggered during the

alarm, look in the log (see page 51).

If You Cannot Reset the System

Your system may be programmed so that it has to be reset by an

installer after an alarm.

If the top line of the

display shows:

Then contact your alarm

installer.

Call Installer:

The installer will either come to your site and reset the system

for you, or, if the system has a suitable communicator fitted,

send a signal to the control unit to allow you to reset the

system.

Remote Reset (aka Anti-Code Reset)

The installer may have programmed your system so that they can

give you a special code to reset the alarm system.

The screen will tell you where the

alarm occurred, for example:

Press tick

Burg Z031 Alarm

It will also show a message asking

you to call the alarm company, for

example:

CALL ARC

Quote 4321

The number displayed on the bottom line is a special code

(“4321” is just an example). Note this code down, you will need it

when you talk to the alarm company.

Press Y to clear the message and the display returns to normal.

Call your alarm company and tell them that an alarm has

occurred.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 103 104

Komentáře k této Příručce

Žádné komentáře

Cooper Security i-on160EX Uživatelská příručka Strana 20

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Cooper Security i-on160EX