Cooper Security i-on 16 Uživatelská příručka stáhnout pdf (Strana 10)

Everyday Operation

Page 8

Quick Set

Quick Setting does not require the use of an access code or tag.

(The Installer must enable this facility for you.)

Make sure the system is idle.

1. Press A.

The keypad gives the exit

warning tone.

Setting:Full Set

10 to set

2. Leave by the exit door and

make sure it is closed

properly.

At the end of the exit time the

display shows the message

"System Set" for a few

seconds.

While the system is set the

display shows the standby

screen.

System set

Note:

If you decide you want to stop setting then press

Part Set

When programming your system, the installer can mark some of

the zones “Part Set”. If, when setting the system, you press B

instead of A then the control unit sets the zones selected by the

installer, and none of the others. This feature is designed so that

you can protect, for example, the perimeter of your house while

you remain inside it, or the downstairs rooms while you are

asleep upstairs.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Žádné komentáře

Cooper Security i-on 16 Uživatelská příručka Strana 10