Cooper Security 9752 Instalační příručka stáhnout pdf (Strana 30)

3. Installation 9752 Installation Guide

Page 26 11976870

When fitting a 9954 hardwired expander, make sure that you place the jumper

link on the expander in the correct position to select either four-wire CCL, or

two-wire FSL (see Figure 18).

FSL

EOL

Four-wire CC

Two-wire FSL

Figure 18. Link Positions to Select Wiring Method

Once you have connected an expander, refer to the instructions supplied with

it for connecting hardwired detectors or "learning" radio detectors as

appropriate.

Addressing Expanders

If you fit expanders, you must allocate each expander to a specific range of

zone numbers. Do not allocate two expanders to the same range of zones.

Select the zone numbers by fitting a jumper link to one pair of the set of pins

marked "Address" on the expander PCB, as shown in Figure 19.

Zones 9 to 16

Zones 17 to 24

Zones 25 to 32

Figure 19. Link Positions to Allocate Expanders to Zones

Note: Other link positions are not valid for the control unit.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Žádné komentáře

Cooper Security 9752 Instalační příručka Strana 30