Cooper Security 9651 Uživatelská příručka stáhnout pdf (Strana 9)

Page 5

2. Everyday Operation

During installation, your installer programs the system to create an exit route

and entry route for your premises. When setting the system, you must follow

the exit route. When unsetting the system, you must follow the entry route. If

you stray from these routes, you may cause a false alarm.

Setting the System

There are several different methods for setting the system. Each level can use

a different method, although not all methods are available in all cases. Your

installer will have selected the methods that suit your site best

The possible setting setting methods for Full Set are:

Timed Set

Final Door Set

The possible setting methods for a part set are:

Timed Set

Silent Set

Instant Set

The setting procedure is similar for each method and shown on page 6.

Subsequent sections describe the specifics of each setting method.

If you try to set the system while something is triggering a detector in the

protected area (for example a door or window is still open), the system will not

set (see page 8).

If you find that your detectors generate false alarms immediately after you

leave the premises, this may be because they are detecting air movements

when the exit door is closed. You may need to ask your installer to increase

the Final Exit Settling Time

Installer Commands 39, 62, 72 and 76

Installer Command 182

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Žádné komentáře

Cooper Security 9651 Uživatelská příručka Strana 9