
3. Setting and Unsetting i-on16
Page 32
Figure 7. Remote Control Button Functions.
The keypad sounds the exit warning tone.
2. Complete setting using the method programmed by the
Installer (see “3. Finishing Setting” on page 24).
Unsetting
1. Enter by the designated entry door.
2. Press on your remote control.
The system unsets. At this point the system displays the standby
screen.
Note: Your Master User may have programmed the control unit
so that you cannot unset the alarm system using a remote
control. See page 82.
If The System Will Not Set by Remote Control
If one of the detectors is still active when you try to set the
system then you will not hear the exit warning tone.
What happens next depends on how the installer has set up your
system.
a) Try pressing A once more on your remote control. If the
installer has programmed the system to do so then it will
carry on and set, omitting the active detector.
b) If the system will not set on the second press of button A
then you will have to go to the keypad and set the system
from there.
Komentáře k této Příručce