Cooper Security 9751 Uživatelská příručka stáhnout pdf (Strana 22)

22 496661

6. Key in two digits for the hour followed by . (Use the 24 hour clock.)

7. Key in two digits for the minutes, followed by .

The display shows the new

time and date:

Turning the Chime On/Off

Your system may be programmed so that a chime tone sounds whenever

certain doors are opened while the system is unset. To turn Chime on or off:

1. Key in your access code.

2. Press 7.

The display shows:

(Press 7 again to toggle Chime OFF.)

3. Press .

Testing the System

Bell Test

You can test that all the sounders and the strobe are working, as follows:

1. Key in your access code.

2. Press 8.

The system turns the external sounder, strobe, internal sounder(s) and

keypad sounders on for three seconds each, one after the other. Note:

The strobe flashes for 10 seconds in order to give you time to see it.

Walk Test

You can set the system so that it will allow you to walk round the premises

and test each of the detectors (a walk test). Choose a time when the

premises are empty to carry out the test, otherwise people may trigger any

movement detectors before you do, and confuse the results of the test.

If any detector fails the test then call your alarm company and ask them to

check the system.

Note: If your system is fitted with 24 hour or personal attack detectors, you cannot

walk test them. If you wish to test them call your alarm company.

1. Key in your access code.

2. Press 9.

This display shows:

3. Walk round your premises and trigger each detector in turn (except 24

hour or personal attack detectors).

4. Special Functions

1 2 ... 17 18 19 20 21 22 23 24

Žádné komentáře

Cooper Security 9751 Uživatelská příručka Strana 22